Design of Steel Structures Mcqs
This set of Civil Engineering Multiple Choice Questions & Answers (MCQs) focuses on “ Design of Steel Structures ”. These Mcqs are chosen from a collection of most authoritative and best reference books on Civil Engineering. Our aim is to prepare an individual for competitive exams like NTS, GAT, ECAT, University and College entrance exams, Jobs and interviews. One should practice our MCQS to assimilate Design of Steel Structures comprehensively.
2. Efficiency of a riveted joint, having the minimum pitch as per IS : 800, is_________________?
40%
50%
60%
70%
3. Bolts are most suitable to carry_________________?
Shear
Bending
Axial tension
Shear and bending
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
4. When the bolts are subjected to reversal of stresses, the most suitable type of bolt is________________?
Black bolt
Ordinary unfinished bolt
Turned and fitted bolt
High strength bolt
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
5. The effective length of a fillet weld should not be less than___________________?
Two times the weld size
Four times the weld size
Six times the weld size
Weld size
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
6. A butt weld is specified by__________________?
Effective throat thickness
Plate thickness
Size of weld
Penetration thickness
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
7. The slenderness ratio of a column supported throughout its length by a masonry wall is________________?
Zero
10
100
Infinity
8. The effective length of a battened strut effectively held in position at both ends but not restrained in direction is taken as________________?
1.8 L
L
1.1 L
1.5 L
9. According to IS Specifications, the maximum pitch of rivets in compression is_____________________?
Lesser of 200 mm and 12 t
Lesser of 200 mm and 161
Lesser of 300 mm and 32 t
Lesser of 3 00 mm and 24 t
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
10. The maximum slenderness ratio of a steel column, the design of which is governed by wind or seismic forces is________________?
150
180
250
350
11. According to IS:800, in the Merchant Rankine formula the value of imperfection index (n) is_______________?
1.0
1.4
1.8
2.0
12. The maximum slenderness ratio of a compression member carrying both dead and superimposed load is___________________?
180
200
250
350
13. According to IS Specifications, the effective length of a column effectively held in position at both ends and restrained in direction at one end is taken as________________?
0.67 L
0.8 L
L
1.5 L
14. The actual thickness of butt weld as compared to the thickness of plate is usually________________?
More
Less
Equal
None of the above
15. For a standard 45° fillet, the ratio of size of fillet to throat thickness is_______________?
1:1
1 : V2
V2 : 1
2: 1