Railway Engineering Mcqs
This set of Civil Engineering Multiple Choice Questions & Answers (MCQs) focuses on “ Railway Engineering ”. These Mcqs are chosen from a collection of most authoritative and best reference books on Civil Engineering. Our aim is to prepare an individual for competitive exams like NTS, GAT, ECAT, University and College entrance exams, Jobs and interviews. One should practice our MCQS to assimilate Railway Engineering comprehensively.
2. The total gap on both sides between the inside edges of wheel flanges and gauge faces of the rail is kept as_________________?
10mm
13mm
16mm
19 mm
3. Anti creep bearing plates are provided on_________________?
Bridges and approaches
Joints
Both (A) and (B)
None of the above
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
4. The maximum degree of curvature for Meter Gauge is limited to_________________?
10°
16°
30°
40°
5. When the rail ends rest on a joint sleeper, the joint is termed as_________________?
Supported rail joint
Suspended rail joint
Bridge joint
Base joint
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
6. Minimum depth of ballast cushion for a Broad Gauge wooden sleeper of size 275x25x13 cm with 75cm sleeper spacing is________________?
15 cm
20 cm
25 cm
30cm
7. For a Broad Gauge route with M+7 sleeper density, number of sleepers per rail length is________________?
18
19
20
21
8. Composite sleeper index is the index of___________________?
Hardness and strength
Strength and toughness
Toughness and wear resistance
Wear resistance and hardness
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
9. Number of dog spikes normally used per rail seat on curved track is__________________?
One on either side
Two outside and one inside
One outside and two inside
Two outside and two inside
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
10. Flat mild steel bearing plates are used_________________?
For points and crossings in the lead portion
With wooden sleepers at locations where creep is likely to be developed
On all joints and curves
On all the above
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
11. At points and crossings, the total number of sleepers for 1 in 12 turnouts in Broad Gauge is______________?
51
62
70
78
12. The type of spike used for fixing chairs of bull headed rails to wooden sleepers is_________________?
Dog spike
Rail screw
Elastic spike
Round spike
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
13. Loose jaws of steel trough sleepers are made of___________________?
Cast steel
Mild steel
Cast iron
Spring steel
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
14. Pandrol clips cannot be used with__________________?
Wooden sleepers
Concrete sleepers
CST-9 sleepers
Steel trough sleepers
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
15. The limiting value of cant excess for Broad Gauge is________________?
55 mm
65 mm
75 mm
L00 mm