Analog Electronics Mcqs
This set of Electrical engineering Multiple Choice Questions & Answers (MCQs) focuses on study of “ Analog Electronics ”. These questions are chosen from a collection of most authoritative and best reference books on Electrical engineering. Our aim is to prepare an individual for competitive exams like NTS, GAT, ECAT, University and College entrance exams, Jobs and interviews. One should practice our MCQS to assimilate Analog Electronics comprehensively.
2. Thermal runaway is not possible in FET because as the temperature of FET increases_________________?
The mobility decreases
The transconductance increases
The drain current increases
None of the above
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
3. A change in the value of the emitter resistance Re in a differential amplifier?
Affects the difference mode gain Ad
Affects the common mode gain Ac
Ffects both Ad and Ac
Does not effect either Ad and Ac
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
4. In a p-n junction diode under reverse bias , the magnitude of electric field is maximum at_____________?
The edge of the depletion region on the p-side
The edge of the depletion region on the n-side
The p-n junction
The center of the depletion region on the n-side
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
5. A constant current signal across a parallel RLC circuits gives an o/p of 1.4v at the signal frequency of 3.89KHZ and 4.1KHZ .At the frequency of 4KHZ,the o/p voltage will be___________?
1 v
2v
1.4v
2.8v
6. The bandwidth of an RF tuned amplifier is dependent on____________?
Q –factor of the tuned o/p circuit
Q –factor of the tuned i/p circuit
Quiescent operating point
Q-factor of the o/p and i/p circuits as well as quiescent operating point
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
7. Most of the linear ICs are based on the two-transistor differential amplifier because of its___________?
Input voltage dependent linear transfer characteristic
High voltage gain
High input resistance
High CMRR
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
8. A dc power supply has no-load voltage of 30v,and a full-load voltage of 25v at full-load current of 1A.Its output resistance & load regulation ,respectively are_____________?
5 Ω & 20 %
25 Ω & 20 %
5 Ω & 16.7 %
25 Ω & 16.7 %
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
9. A 741-type OP-AMP has a gain-bandwidth product of 1MHz. A non-inverting amplifier using this op-amp & having a voltage gain of 20db will exhibit -3db bandwidth of__________?
50 KHz
100KHz
1000/17 KHz
1000/7.07 KHz
10. In the differential voltage gain & the common mode voltage gain of a differential amplifier are 48db &2db respectively, then its common mode rejection ratio is__________?
23dB
25dB
46dB
50dB
11. An amplifier without feedback has a voltage gain of 50,input resistance os 1 KΩ & Output resistance of 2.5KΩ.The input resistance of the current-shunt negative feedback amplifier using the above amplifier with a feedback factor of 0.2 is___________?
1/11KΩ
1/5KΩ
5KΩ
11KΩ
12. An ideal OP-AMP is an ideal___________?
Current controlled Current source
Current controlled voltage source
Voltage controlled voltage source
Voltage controlled current source
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
13. The current gain of a BJT is__________?
Gm r0
Gm / r0
Gm rπ
Gm /rπ
14. To prevent a DC return between source and load, it is necessary to use___________?
Resistor between source and load
Inductor between source and load
Capacitor between source and load
Either A. or B.
Answer & Solution
No Solution for this Answer..! Report or Discus this Question
15. Voltage Series feedback also called series-shunt feedback) results in__________?
Increase in both input & output impedances
Decreases in both input & output impedances
Increase in input impedance & decreases in output impedance
Decrease in input impedance & increase in output impedance
Answer & Solution
No Solution for this Answer..! Report or Discus this Question